Shopping Cart

Your cart is empty.

Your cart is empty.

FLIPSKY Dual Electric Speed Controller for Skateboard FSESC6.7 140A Base on VESC6.6 with Aluminum Anodized Heat Sink

5.0 Write Review
Free shipping on orders over $29.99

$217.72

$ 71 .28 $71.28

In Stock

About this item

  • More Control Modes:Support four control modes: Current/Dutycycle/Speed /Position control mode.
  • Upgrade Performance:Latest Version Firmware,support rich control interface and sensors,programmable.Warm tips: It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.
  • Support the function of balancing car by connecting the IMU module through the IIC interface; support inertial measurement unit modules such as MPU9250, MPU9150, MPU6050, LSM6DS3, BMI160.
  • Continuous current: 140A; instantaneous current: 400A.Voltage: 14V-60V(Cells: 4-13S; safe for 4S to 12S, voltage spikes may not exceed 60V! ).
  • Size:79.8*66.8*17.8mm.Widely applications:e-skateboard,ebike,scooter,robot etc.
  • Top Service: If there are any question or need help , just feel free contact us , we will always here help you out within 24 hours.


Warm tips:It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.


Specs:

  • Firmware: Latest Version.
  • Continuous current: 140A; instantaneous current: 400A
  • Voltage: 14V-60V(Cells: 4-13S; safe for 4S to 12S, voltage spikes may not exceed 60V! )
  • BEC: 5V@1A
  • ERPM: 150000
  • Control Interface Ports:USB,CAN,UART,SPI, IIC
  • Supported Sensors:ABI，HALL，AS5047，AS5048A
  • Input Set Support:PPM, ADC, NRF, UART
  • Modes:DC, BLDC, FOC (sinusoidal)
  • Regenerative capacity: Yes
  • Programmable: Yes
  • Motor wire: 12AWG
  • Power cable:14AWG (with XT90 connector)
  • Size:79.8*66.8*17.8mm


Feature:

  1. Support four control modes: Current/Dutycycle/Speed /Position control mode.
  2. Protection functions: low voltage protection, high voltage protection, over-current protection, temperature abnormally protection, mosfets over-temperature protection.
  3. Support the function of balancing car by connecting the IMU module through the IIC interface; support inertial measurement unit modules such as MPU9250, MPU9150, MPU6050, LSM6DS3, BMI160.