Your cart is empty.
Your cart is empty. Product Details:
Oil Pressure Sender.
Input: 0-100 psi.
Output: 240-33 ohms resistance. Isolated to ground.
Accuracy: within 5% full scale.
Thread: 1/8”-27 NPT.
Wiring connectors: 8-32 stud, wind the cable onto the screw,and then screw it up through nut.
Symbols: G for signal, should use wide connection, "WK" for ground, should use narrow connection.
My Review
Reviewed in the United States on March 21, 2025
Absolute junk! Like others have said then sender stops working after a short period of time. When you use an ohm meter, between the two post it completes the circuit, therefore the internal resistance has failed.
Ali Nayak
Reviewed in the United States on June 6, 2024
This sending unit stopped working for anything less than 40 PSI (went to zero) then it would jump up to correct pressure. This caused a panic that I had actually lost oil pressure and had to pull to the side of the road to troubleshoot.
Clients amazon
Reviewed in Canada on February 1, 2024
Faite attention ne serrez pas trop fort les boulon la tige filleté casse facilementSinon fonctionne super bien bon remplacement pour le 2242 de autometer qui est assez chère
Customer
Reviewed in the United States on July 18, 2021
works
Recommended Products
$156.73
$ 68 .39 $68.39