Your cart is empty.
Your cart is empty.Forget the pull chain! Use a fan control switch for your ceiling fan! The Leviton SureSlide Fan Speed Control provides quiet operation with low, medium and high fan speed settings. A separate on/off switch preserves the selected fan setting. Replaces an existing wall switch that controls the ceiling fan with no neutral wire required for installation. 1.5 Amps, 120VAC, 60Hz. Single pole or 3-way fan control when used with a 3-way switch. Ideal for use in bedrooms, home offices, living rooms and any area where ceiling fan noise could become distracting.
Matt
Reviewed in the United States on March 28, 2025
I waited too long to install these. None of them worked, don’t buy from here. Buy from a local store. These are garbage.
Rémy
Reviewed in Canada on March 17, 2025
doesnt work at all, even verify it with ohm meter, possible that they buy defective item load and sell them on amazon ????
JG
Reviewed in Canada on August 25, 2024
I've bought these many times from different retailers. And they work excellent.However ...The last time I got these in the two pack, one of them has a sticky/catchy slider and does not operate smoothly.
Dr Michael
Reviewed in the United States on September 21, 2023
Got tired of standing on the bed to use the pull chain to control the ceiling fan speed. Replaced a simple on-off wall switch with this one and now I can set 3 speeds from the wall, as well as turn the fan on-off. Wiring was simple (single pole) remembering to shut off the power breaker to the fan before replacing. This wall control works fine with this Hunter fan but should also work with any other ceiling fan brand.
Tobi Chevy
Reviewed in Canada on July 31, 2023
Fan control has 3 positions.Low- doesn't work. Fan will not turn. Only groansMedium - works, but fan speed is only slightly below high setting. Still very loud.High - Fan runs at maximum speed and is loud.
awdiokreep
Reviewed in the United States on November 14, 2023
No more pulling the chain. This switch has an on/off switch and a speed slider switch. Pull the fan switch chain to set the fan on high, and you will never have to use the chain again. Keep in mind that if you have a fan with a light kit (all of mine have light kits), you will need an extra hot lead run from the switch box to the ceiling box. I ran new 12/2 Romex at 5 different locations in my house, but probably would have been better to use the existing cable to pull in a 12/3 Romex. Then I replaced the existing single-gang wall switch boxes with 2-gang old-work plastic boxes. It can be difficult to reroute the existing cables into the new box. This is all labor intensive since the original Romex cables are stapled to the stud inside the wall a few inches above the wall-switch box. An electrician would have charged in the thousand$$ for a job like this. But, once installed, this switch works flawlessly to control a standard 3-speed pull chain ceiling fan. I used similar Lutron switches in some of the locations. Either brand is an excellent choice, but the Lutron brand might be easier to find.
Patrick Ruest
Reviewed in Canada on June 4, 2022
Easy to install.
Customer
Reviewed in the United States on August 26, 2021
This switch was easy to install and works very nicely. Just the one my wife wanted!
RAC
Reviewed in the United States on December 16, 2021
Replaced six old controls throughout the house. Old Hunter tabs had broken off. These are much better designed, slide easily and were very easy to install. I actually purchased all used units, ranging from "Like New" to "Good" condition for a greatly-reduced price. All of the units appeared to be never used (wire tips intact) and in perfect condition. Highly recommended.
Recommended Products
