Your cart is empty.
Your cart is empty.
A high-quality in-line SMA DC Block. 50kHz-8GHz operation.
The maximum power is 2W and maximum blocking voltage is 50V. Insertion loss of Laser-etched labeling. Full 2 year service and support!
A. J. E.
Reviewed in the United States on May 18, 2024
I use this to isolate my LNA from the rest of the electronics. After nearly a year I have had no problems.
Zachary Iles
Reviewed in Canada on February 4, 2024
Remember, these are for SHORT TERM use. You do not use them at the top of it's rated DC power while doing TX or RX for long periods (multiple hours), They will get hot, and that will impact your signal.
Moi
Reviewed in France on April 7, 2024
Le produit a l'air assez solide la réponse en fréquence est correcte aucun problème...
Nick Abelas
Reviewed in Australia on December 10, 2023
Performs as stated. Well built. Very happy with it.
comicsansgreenkirby
Reviewed in Canada on August 29, 2022
I'm not seeing much signal loss with this inserted. While it was unfortunate that I didn't see the Ham It Up Nano needed a DC blocker for some RTL sticks, it does very well.Simple but effective, and not as janky as the other solution was gonna be x>x
HAMテスター
Reviewed in Japan on July 20, 2022
ＳＤＲ用の保護とスペアナの保護に使っています。もう少し長さが短いと使い勝手が良いのですが、長過ぎます。
LaneWilson
Reviewed in Canada on October 12, 2021
Was used with a TinySA device
Gabriele D.
Reviewed in Italy on June 15, 2020
Non proprio economico ma funziona!
Terry Bendell
Reviewed in Canada on May 25, 2020
It works well but very pricey.
Chad Ohman
Reviewed in Canada on January 9, 2020
It does the job! Blocked the voltage from a SAWbird+NOAA back to the SDR. Unfortunately this solution was not going to work for my installation and instead went with an SDR with bias-tee.
Recommended Products
$23.75
$ 11 .51 $11.51