Shopping Cart

Your cart is empty.

Your cart is empty.

WMYCONGCONG 5 PCS Joystick Breakout Module Game Controller Compatible with Arduino PS2 + 120 PCS Multicolored Breadboard Jumper Wires Ribbon Cables Kit

4.5 (5) Write Review
Free shipping on orders over $29.99

$12.95

$ 5 .75 $5.75

In Stock

About this item

  • Game joystick module compatible with Arduino PS2, electronic building blocks connector with 2.54mm pin.
  • DO port for digital output, AO port for analog output; Bi-directional 10 k resistor, the resistance changes with the rocker in a different direction.
  • Module uses 5V power supply, the original state of X, Y read voltage of 2.5 V. When pressing at the line tip direction, voltage increases, maximum is 5 v, at opposite direction of the line tip, the voltage value decreases, minimum is 0 v.
  • Jumper wires kit, compatible with 2.54mm spacing pin headers, great for Arduino PCB project, pc motherboard.
  • Package include: 5 * XY joystick module(NOT designed for high current applications.) + 120 * ribbon Cables Kit(including male to male, male to female, female to female).


Specification:
Joystick Breakout Module:
DO port for digital output, AO port for analog output.
Size: 37 x 25 x 32mm/1.46 x 0.98 x 1.26inch
Weight: 15 g
Connector: +5Vcc - GND - VRx - VRy - SW
Material: ABS plastic
Game joystick module suits for Arduino PS2 , connects to two analog inputs, the robot is at your commands with X,Y control.
It also has a switch that is connected to a digital pin, convenient to use.
Breadboard Wires Jumper Wires:
40-pin male to female jumper wires
40-pin male to male jumper wires
40-pin female to female jumper wires
Each Cable Length: Approx. 200mm/7.87inch
Great accessories for Arduino breadboard kit project, PCB project, pc motherboard.
Package content:
5 * Joystick Breakout Module
40 * 2.54mm Breadboard Wires Jumper Wires Male to Male
40 * 2.54mm Breadboard Wires Jumper Wires Male to Female
40 * 2.54mm Breadboard Wires Jumper Wires Female to Female


Nancy
Reviewed in the United States on March 11, 2024
When I received the package the plastic was broken
Rich from Idaho
Reviewed in the United States on April 26, 2023
I used these with my Arduino UNO R3 and they worked great. The wire connectors were a nice addition. I would purchase these again.
R Sidell
Reviewed in the United States on February 16, 2021
Used this with an Arduino board and it was great! And I love that it came with so many jump wires.
Ivy Piatt
Reviewed in the United Kingdom on September 14, 2020
The X and Y resistors work, but the baselines for both are different. I measured a baseline of 500 for X, and 506 for Y. The buttons don't work, and I have not yet got them to work.
Eero
Reviewed in the United States on December 27, 2019
The joystick potentiometers do not have a smooth response - they go from 0KOhm to 10KOhm in a nearly binary manner. If that is all you need, they may do the job. Seems like these may be reject joysticks.