Your cart is empty.
Your cart is empty. Description：
Black hard surface rocker.
Rated at 3Amp 12V.
High quality single pole single throw ON-OFF push switch.
Face surface size: 39 mm x 21 mm（1.54“ x 0.83”）
Uses the original mounting hole of the vehicle.
These switches are an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
This Switch Suits the following models:
Toyota Prado 120 Series 2003-2009
Toyota FJ Cruiser 2010 - 2013
Toyota Hilux KUN26R, GGN15R, GGN25R 2005 - Current
Toyota Highlander 2001-2007
Toyota Tacoma 2005-2011
Toyota 4Runner 2003-2009
Toyota Landcruiser 100 Series 1998 - 2007
Toyota Fortuner 2005-2014
Installation Instruction：
It is simple to connect the switch: The Green wire 1 goes to the battery, the red 2 w/yellow stripe closest to green wire goes out to the relay; the black 4 wire connects to the ground, while the red 3 w/yellow stripe closest to black goes to the dash
Contents:
1 x Pushbutton Switch
1x Connector Wire
NOTE:
1. Pls check the size of the item and measure the hole you want to place before placing an order, in order to make sure it fit for your vehicle.
2. The switch is an electronic switch rated at 3 Amp. Therefore in ALL cases the accessory MUST be wired through a fused relay.
