Your cart is empty.
Your cart is empty.Maintain your Chevrolet, Buick, GMC, or Cadillac vehicle with a Genuine GM Parts Power Steering Pump Pulley. Only Genuine GM Parts are tested to meet GM Original Equipment standards and are designed specifically to fit your vehicle.
Speedweigand
Reviewed in the United States on November 25, 2023
Does not fit 06 Pontiac GTO
francisco garcia
Reviewed in the United States on August 30, 2022
V6 chevy camaro onlywont fit ls1
paul jaramillo
Reviewed in the United States on August 1, 2022
good deal
Matt
Reviewed in Canada on May 6, 2022
Come up when looking for a pully for my brothers camaro. Pully was way to big. More Amazon's fault than the sellers for saying it would fit the car
ricardo
Reviewed in the United States on August 27, 2021
Fit my 6.0 for a corvette power steering pump.
JT
Reviewed in the United States on June 9, 2020
I attempted to install this pulley with the proper tool and it went on 90% of the way and stopped and would not move with 3/16” to go. I removed it and checked everything and did not see any issues. Cleaned the inner hub of the pulley and the shaft of the pump and tried it again. Same results. Took it back apart and cleaned the shaft of the pump with fine grit sand paper to make sure there were no hidden burrs. I tried again with the same failed results. Took it back apart and accidently dropped the pulley. It dropped a few inches and hit the car’s cross member, and then, of course, fell the 2 feet to the floor and put 2 chips in the outer flange of the cheap plastic. At the point I figured the pulley will be replaced but I am going to figure out why it won’t go on. I used a brake hone and gave the inner hub about 15 seconds of hone time. This time the pulley went all the way on correctly. There must have been some small flaw in the hub the hone took care of. I am going to find a replacement that is better of quality material.
Recommended Products