Your cart is empty.
Your cart is empty.The DEWALT 1/2” x 6’ Lead-In hose is used to connect your air hose reel to your compressor and is made to help absorb the shock loads produced by air powered tools. The hose is oil resistant with solid brass ½ inch NPT male end fittings which never corrode. The DEWALT 1/2” x 6’ Lead-In hose is the perfect accessory for any air tool and any air compressor that operates at 250 PSI or less.
QO Metrology
Reviewed in the United States on March 12, 2024
Nice heavy-duty unit. Just the perfect size for what we needed.
Pat
Reviewed in Canada on December 19, 2023
1/2 hose with less than 5/16 inside fitting because of the swivel
Mark Freeborn
Reviewed in Canada on December 16, 2023
Exactly right piece
Paul Y. in Texas
Reviewed in the United States on November 6, 2023
This was used to connect a compressor to fixed air lines on the wall/throughout the building. Works perfectly after after a couple of months, no issues or signs of trouble.
Ventflow Air Duct Cleaning
Reviewed in the United States on October 4, 2022
Currently running 200 psi at around 80°-90° Has been holding up under extreme conditions hot and cold excessive vibration etc. No leaks loose nut ends for easy installation. Perfect length for a lead hose. No complaints good quality.
City Musician
Reviewed in Canada on June 27, 2020
This is a quality product that has a swivel end on one side to make is very easy to attach .
Dave Birdman
Reviewed in the United States on December 5, 2020
Nice product.One side has a swivel collar. So, you don't need a quick connect. Just turn in one side turning the hose with it. The other side just turn collar to thread into fitting.Works and looks great!
PVC
Reviewed in the United States on January 9, 2020
The good: Nice hose with a swivel joint on one side I was not expecting.The bad: As can be seen the inside of the fittings is nowhere close to 1/2". It only measures .278". Have not run a high flow through them but it has to be better than my 3/8" hose I had before.
Recommended Products
