Your cart is empty.
Your cart is empty.The IP710-DLZ dual voltage 0-10V dimmer is designed to dim lighting in commercial spaces such as hotels, restaurants, offices and other public spaces. This dimmer controls the ballast directly which allows dimming of the lighting fixture without the need for a power pack. Works with the latest array of 0-10V LED fixtures and dims from 10%, 1% or as low as 0.1% with compatible driver. LED locator light makes it easy to find the dimmer when dark. 1200VA @ 120VAC, 1500VA @ 277VAC, 10A LED/Electronic Ballast 120/277VAC, 60Hz, 50mAmps maximum sinking current. Single pole or 3-way control when used with 3-way switch. Comes in white, with ivory and light almond faceplates included. Wallplate sold separately.
mm
Reviewed in the United States on May 10, 2024
Worked well as a replacement
David J
Reviewed in the United States on June 24, 2022
Item is of champion quality. Remarkably incomparable delivery. Pretty packaging.
MeccanoManStan
Reviewed in the United States on February 22, 2022
Easy install (except getting wires though the wall) - added dimmer to old location. Works to dim a big 2x2 square 40W LED light.LIJ
Darokizs
Reviewed in Canada on January 5, 2022
works as desired for 10vdc LED dimmer. the on/off switch is a little noisy and could be more refined.
C. Malinowski
Reviewed in the United States on December 24, 2019
Great product. Easy to use. Nice lighted feature.
MadPB
Reviewed in the United States on December 22, 2019
I installed this to control a new set of four overhead 4ft LED fixtures with 0-10V dimming.Wiring them up was pretty simple... normal hot/neutral/ground wires, plus daisy chaining the 0-10V wires between the switch and each fixture.Two complaints though... first, the price seems too high, in my opinion. I wanted the dimming, so I paid the price, but something tells me it shouldn't be as high as it is just for that dimming feature. Then again, something is worth as much as people are willing to pay, so...The other complaint was that until I put the cover plate on, the replaceable faceplate on it kept popping off. I had installed the switch in a double-gang box and until I hooked up the other switch, I didn't have the Decora plate installed. Meanwhile, I was running some other wires in nearby locations, and everytime I'd hammer a wire staple into a stud, the smallest vibrations would make that cover pop right off. It's just not held on very well. It's plastic so it didn't break when it fell to the floor, but still, it seemed chintzy for such an expensive switch.Of course once the cover is installed over the switch, that holds it in place just fine so it's not ultimately a big deal, but it sure was frustrating until then.The dimming itself works well. It's fairly smooth, and the full brightness matched the brightness of the fixtures when I tested them out with a non-dimming switch, as best I could tell. The lowest dim level will depend on your specific fixtures, and I have nothing to compare on that front, but it dims pretty low so I'm satisfied.I have this wired in a 3-way configuration (to a non-dimming switch) so that part of the switch works fine too - it does support 3-way just fine with the traveler wires.
Recommended Products
