Your cart is empty.
Your cart is empty.
Specifications:
1.Analog input
Analog inputs use 20 bits AD chip, CountSpeed up to 80 times / sec, the measurement accuracy of 0.2%
Display range -9999 ~ 19999
The largest sub-degree 50000
For the bridge voltage 5V, 100mA
2.The switch output
3 relay or OC outputs. Relay contacts AC250V / 1A, OC output drive 100mA / 48V optional.
5. Asimple comparison output
Features: 3 output meter can be set to begreater than or less than the comparative comparison. When the measured valueexceeds the upper limit output is active when the measured value is less thanthe upper limit minus hysteresis output is invalid. If the output is less thancomparison, the measured value is less than the lower limit of the output isactive when the measured value is greater than the lower limit plus hysteresisinvalid.
if you want transmitter 4-20mA out, you can see here: https://www.amazon.com/dp/B07KK361W4?ref=myi_title_dpPurpleThunder
Reviewed in the United States on July 1, 2021
Wasn’t able to correctly calibrate either of my (2) Calt load cells with this Calt controller display. Help from Calt in China didn’t help resolve the issue. There was a 15% linear error. Repeatability wasn’t bad at just under .2%
Recommended Products
CA $122.02
CA $ 60 .99 CA $60.99
CA $6.99
CA $ 3 .99 CA $3.99