Your cart is empty.
Your cart is empty.QWORK
Customer
Reviewed in the United States on March 4, 2025
Worked perfectly, used under a house. Was able to raze it to get the support as needed.
Joseph B. Lamons
Reviewed in the United States on March 20, 2025
Other than pressure release screw labeled backwards, jack worked very well. I did not test it anywhere near capacity, but it has low clearance and lifted a few tons easily.
m e bednarski
Reviewed in the United States on March 19, 2025
Works but seems like it is low on hydraulic fluid. No instructions on fill level, etc.
mike y.
Reviewed in the United States on February 1, 2025
Pump doesn't work, had to change fitting on ram to make it compatible with portapower pump. Ram works fine.
Customer
Reviewed in Canada on April 24, 2025
The unit didn't work out of the box. It appears there is no hydraulic fluid. There are also no instructions on how to bleed the air and refill the cylinder with hydraulic oil. I spent over an hour bleeding some air and adding hydraulic fluid at both the pump and jack ends, but it still didn't work. A simple page of instructions would have gone a long way and saved a lot of wasted time.
930bob
Reviewed in Canada on November 2, 2024
I needed a small port-a-power with a short ram, this worked perfectly for my project with much more reserve power than I required.
ED GEER
Reviewed in the United States on October 4, 2024
I needed to remove the stump jumper of my bushhog. My t-bar puller just couldn’t put enough pressure on the spline to break the hub loose. The low profile of this ram fit nicely under the bar and popped the hub free easily. Now it did sound like a rifle shot when the hub broke free, but beside a little pee in my pants all is well.
Recommended Products