Your cart is empty.
Your cart is empty.This is a brand new, never used, low pressure hydraulic brake light switch. It is a direct replacement for any out-dated switch in any brake system. The switch turns brake lights on at 45PSI, rather than 95PSI on old switches, allowing for a faster signal to your brake lights. This switch is 1/8" NPT and is used on many old Ford and Mopar vehicles. It has a T-fitting with a top port of 1/8" NPT and two side ports of 3/8-24 inv. flare. This switch is a must for any new brake job and will ensure that your brake lights are working properly.
David G Hessler
Reviewed in the United States on March 8, 2025
Worked perfectlyNo leaks
Customer
Reviewed in Canada on February 12, 2025
Mark Harris
Reviewed in the United States on January 18, 2025
awesome
Carl
Reviewed in the United States on April 6, 2025
No real complaints about the item, it works as expected although the on/off pressures are a bit wonky, but close enough. I am sure they are all slightly different, but the switch I got closes at 32-PSI and opens back up at 30-PSI. Turns the brake lights on and off just, so no big deal. So far, does not leak but it's only been on the vehicle a few days now. I would recommend you order pigtails for the switch connectors, unless you are replacing an existing switch with the same connector style. So far so good, and brake lights on the hot rod now!
Tdub
Reviewed in the United States on September 26, 2024
Have tried for 90 days to get light working on our trike, finally tried a low psi switch, and it worked.Riding again
Ron c
Reviewed in the United States on August 26, 2024
Need to supply wire connectors with this!
Recommended Products
$10.79
$ 5 .75 $5.75
$33.59
$ 17 .99 $17.99