Your cart is empty.
Your cart is empty. 1.10 Pieces hex socket head cap bolts screw lock flat washers, M4 x 30mm (Head does not included).
2.The hex socket head cap screw is made of 304 stainless steel cold forging.
3.The fastener is mainly used for the installation and connection of furniture, steel frame, mechanical equipment, electrical appliances, etc., and has strong connection strength.
The washer on the bolts cannot be removed，which makes it easier to install and use.
Specifications:
● Threaded Size: M4
● Threaded Length: 30mm
● Threaded Pitch: 0.7mm
● Drive Type: Hexagon Socket
● Material: 304 Stainless Steel
● Main Color: Silver
Package Quantity:
● 10 Pieces
Boltech
Reviewed in Canada on March 16, 2025
Thank You!
Albert
Reviewed in Canada on February 3, 2025
It is what it is! Just wish could remove the washers.
bryan
Reviewed in the United States on August 31, 2024
Is as described. Thanks
rndeleon
Reviewed in the United States on November 6, 2024
Vacuum didn't come with screws but these were the ones I needed to replace them after looking at a parts diagram and measuring
valeri
Reviewed in Canada on November 20, 2024
Works good
Grant Colli
Reviewed in Canada on October 20, 2024
Work as expected
Jeff Decker
Reviewed in the United States on September 13, 2023
These bolts were great quality but I needed them without the washer and the washer wouldn't come off without me cutting it. Wish the washers came off a bit easier other than that they're great!
Customer
Reviewed in Canada on May 29, 2023
Perfect fit and finish
Customer
Reviewed in Canada on March 24, 2023
For what these are, they're perfectly fine. Personally, I had to cut and pry the washers off.
DJTRADES
Reviewed in Canada on October 17, 2023
Used stainless M3 bolts to hold down Captian liquid CPU cooler to AMD X670 motherboard.
FatBob FXDF
Reviewed in Australia on November 26, 2022
good product & service
Rebecca
Reviewed in the United States on September 6, 2020
As another reviewer said, the spade tip looks awfully big, and I was half expecting the screws to strip the hole. I just installed E Track rails in a cargo trailer with them, and bam! they hold just fine. Great to have the variety pack, as I needed different sizes for the walls and floor. I did pre drill a slightly smaller hole so I would not risk overheating and snapping the screw. I ran the screws most of the way in with a drill, but then hand tightened them, as it would have been a royal pain if any had broken (which they did not).
Mark MacConnell
Reviewed in Canada on July 3, 2020
Product as described. Works well for my needs.
Recommended Products
