Your cart is empty.
Your cart is empty.Product Description
Bike flashlight mount bicycle holder
Rotated by 360 degree, you can adjust the LED flashlight to any angle.
Adjustable clip size, suitable for body diameter from 0.7 to 1.5 inch.
Easy installation and mount for flashlights, Inflator and U lock.
Anti-skid pad protects flashlight and bicycle from scratches.
handy man
Reviewed in the United States on September 6, 2022
They seem of decent quality. Do exactly what their supposed to do. Just takes a lil bit longer to use than I need. The rubber o-ring for different size flashlights is hard to keep from falling off. There's so many other quick release flashlight holders out there. But these r a good secure way to mount flashlight. Not too bad at all
Ro Jameson
Reviewed in the United States on August 7, 2022
Its kind of annoying to release and put on. The construction is solid for plastic, its just bulky and you have to unscrew the latch to fully release the clamp for removal or installation.
Jim H
Reviewed in the United States on December 11, 2022
I wanted to put this on a pole in the ground so I could hold a flashlight. I just wrapped some duct tape several revolutions to make it wide enough to squeeze it. Quick disconnect is not really quick disconnect, it's more like quick loosen. You still have to spin the bolt many times to loosen enough to remove it. If you are going to need the plastic inserts to change the sizing, you might as well glue them on permanently, because they otherwise will fall to the ground when you open and loosen them.
todaniels71
Reviewed in the United States on October 11, 2020
I got this 3 Pack of Bicycle Bar/Frame Holders for multiple different purposes. I already setup up one w/ the CREE Stun Gun Flashlight (previously bought on Amazon.com). It is so far Awesome!! The Stun Gun is Super Long & I attached it by the Folding Neck/Bar that goes up to the Handlebars. I can click the Holder up & down to see what I need to OTR. I bought the 3 pack cause I have 4 e-Bikes I have built & one that already has a similar setup. I was getting an idea how quickly & efficiently I can get the Stun Gun/Flashlight off the Holder. It seems that won't be a Major Issue. When I go into Stores/Places I ride to also I will be doing that anyway. Been Building & Riding 5+ years. This Connector/Holder looks like it will work out just fine!!
Duck995
Reviewed in the United States on November 3, 2019
I bought these to use on my electric mobility scooter after the lights stopped working. The clamps themselves are okay - and the ability to rotate 360 degrees was exactly what I needed. The "quality" rubber inserts are not very high quality and are hard to keep in place while trying to mount the clamp. They fall out easily and are very hard to get back in place. I finally used some rubber cement to hold them in place because they kept falling out - very frustrating.I only needed one, and wish you could buy these in singles. Not sure why they come in packs of three - I hate keeping things around that I don't need, but I also hate to throw away something that is still useable.Since I did not find any other similar clamps, I would buy them again. If you do buy them, expect to have trouble with the rubber inserts and plan on having some rubber cement on hand to keep them in place.
Recommended Products
$25.27
$ 12 .95 $12.95