Your cart is empty.
Your cart is empty.Product Description
1.8 inch SPI TFT LCD Display Module
- The 1.8 inch SPI TFT LCD Display Module is suitable for beginners who have just connected to a touch color screen, LCD enthusiasts and MCU learners who pursue display effects. Just occupy your 5 IO ports, you can enjoy the TFT display effect. The craftsmanship is superb, all reflow soldering is used, no hand soldering burrs, and each screen is attached with a clean protective film that can be peeled off when in use.
Andy
Reviewed in Canada on September 10, 2024
Not touch screen like it shows explicitly in its advertising
Logan Weir
Reviewed in Canada on July 29, 2024
I connected this to an ESP32 and was up and running in no time, there is alot of documentation and code libraries available for this display.
marc paradis
Reviewed in Canada on April 1, 2024
Parfait
Olivier Lavoie
Reviewed in Canada on March 12, 2023
Utilisé comme thermostat avec Home Assistant, branché sur un esp32/esp8266.control d'intensité pour la luminosité,
A Bastien
Reviewed in Canada on February 22, 2023
Screen has a hole in it. The packaging from the vendor and Amazon where not sufficient to prevent damages. The screen has a hole in it probably from the unit on top of it since the pins are sticking out of the foam and bag it was stored in.Sending it bad DOA. Does not work with ST7735 or ILI934 libraries. Tried many variations.
DARCY ROBERTS
Reviewed in Canada on November 22, 2022
Got the display to work with Arduino due. As others have noted, Silkscreen SCL is SCK, SDA is MOSI, A0 is DC, although board also says SPI. LCD arrived with crack along one side, leaving a noticeable black splotch. Also had a few red / green vertical lines that don't go away. Unsatisfied with this product overall.
Joseph R Heiderman
Reviewed in the United States on October 1, 2022
It works unlike another slightly cheaper brand
charlotte omnes
Reviewed in the United States on March 7, 2021
I never could get the SPI working on an UNO or a Nano Every. It lit up just fine and showed a default brush stroke on screenSDA should be either called SDI or MOSI for an SPI screen and go to pin 11 on an Uno, (SDA is used for I2C communication)SCK pin should connect to your SCK (pin 13 on an Uno)A0 is referred to as DC in Adafruit's code.Don't use this screen if you are a beginner...Not sure if mine was defective, but I spent a few hours trying make it work and failed...
jdog2u
Reviewed in Canada on May 23, 2020
Like how is was packed
Alex Gerchanovskiy
Reviewed in the United States on August 29, 2019
I've used this LCD screen in my FLIR camera DIY project. Very bright and colorful
Recommended Products
CA $184.68
CA $ 85 .99 CA $85.99
CA $54.89
CA $ 25 .99 CA $25.99
CA $20.89
CA $ 9 .99 CA $9.99
CA $110.23
CA $ 45 .99 CA $45.99