Shopping Cart

Your cart is empty.

Your cart is empty.

6-Pack ESP-WROOM-32 Development Board,Aideepen 30PIN ESP32S ESP-WROOM-32 Board 2.4GHz Dual-Core Compatible with Arduin, Nodemcu,and MicroPython

Free shipping on orders over CA $49.99

CA $49.99

CA $ 22 .99 CA $22.99

In Stock

About this item

  • Ultra-small;ESP32 ESP-32S NODEMCU Micro USB Dual Core Development Board Module, you can easily embed it in other products. Via SPI / SDIO / I2C / UART interface.
  • Cost-effective:Low power consumption, more third party firmware support.
  • Easy Use:Supports nodelua, microPython, Freertos and other firmware. Support Lwip protocol. In addition, it can be connected to other HTTP APIs to achieve data capture and use Iotapi to call each other.
  • ESP-WROOM-32 chips:Tensilica LX6 Dual Core CPU processor, calculation speed 600 DMIPS. Built-in 520 KB SRAM. Supports three modes: AP, STA, and AP + STA.
  • Product parameters;Size 58 * 28 * 12mm. It comes with 30 pins (with welding and mark). One Micro USB interface (built-in CP2102 USB-TTL module). Two physical buttons (EN+BOOT). Two LED indicators.



Product Description

6-Pack ESP-WROOM-32 Development Board,Aideepen 30PIN ESP32S ESP-WROOM-32 Board 2.4GHz Dual-Core Compatible with Arduin, Nodemcu,and MicroPython

ESP-WROOM-32 Development Board

Aideepen 30PIN ESP32S ESP-WROOM-32 Board

6-Pack ESP-WROOM-32 Development Board

  • Ultra-small:ESP32 ESP-32S NODEMCU Micro USB Dual Core Development Board Module, you can easily embed it in other products.
  • Via SPI / SDIO / I2C / UART interface.
  • Cost-effective:Low power consumption, more third party firmware support.
  • Easy Use:Supports nodelua, microPython, Freertos and other firmware.
  • ESP-WROOM-32 Development Board comes with 30 pins (with welding and mark).
  • Support Lwip protocol.
  • ESP-WROOM-32 chips:Tensilica LX6 Dual Core CPU processor, calculation speed 600 DMIPS.
  • Built-in 520 KB SRAM.
  • Supports three modes: AP, STA, and AP + STA.
  • One Micro USB interface (built-in CP2102 USB-TTL module).
  • Two physical buttons (EN+BOOT). Two LED indicators.
esp32 30pin
esp32 30pin

Eric Woodard
Reviewed in the United States on March 20, 2025
Great devices on the cheap and fast!
Trelane Esq
Reviewed in the United States on March 18, 2025
First two that I plugged in, the USB connector broke off the board.The USB connector is TIGHT... The solder tabs on the housing are TINY and there's BARELY any solder holding them.The first one broke off the board and broke the contacts.The second one (I was being careful) broke off the board but the contacts were still connected. I resoldered the connector but the tabs are TINY so it didn't hold.BEFORE you use these, GLUE the connectors down with JB Weld! See my picture.***UPDATE: The seller contacted me and offered to 'make this right'. Gonna give them 3 more stars because they didn't have to do this. Develop your sketch on another ESP then JB Weld and CAREFULLY connect the USB and upload your sketch.
zombie hoffa
Reviewed in Canada on March 17, 2025
great quality but the module is now the "D" variant and the pin out does not seem to fully match the picture or the one posted in the reviews. It's a shame because otherwise these feel super quality.Edit: They updated the pin out so I have am chaning my review to 5 stars.
JW
Reviewed in the United States on April 1, 2025
I finally made the switch from Arduino to ESP32 - what a difference! I was up and running very quickly since the Arduino IDE easily recognized this module. I'm just OK with coding but with the help of an online AI program, I was getting several projects running fast! Hook up is a breeze as all of the pins are identified by silk screened markings. The only downside to this is the pin spacing from one side to the other - it's too wide for my old prototyping breadboard (it's one row too wide to fit). Luckily, for my project shown, I only needed 4 pins that were all on the same side. I'm going to order a new breadboard to address this issue. The module is very well built and has two onboard LEDs and two buttons - one of which is a handy reboot. At around $5 per module, this is a GREAT deal!
Bill Sullivan
Reviewed in Canada on August 20, 2024
These just work. easy to program, come with pins pre soldered for easy wiring. I have been able to power small projects with only using the USB port for power. They seem to be protected well cause even with hot swapping, shorting out or reverse polarity they just reboot and keep on truckin.
Sythe
Reviewed in Canada on August 1, 2024
Not too much to say. Good developemnt boards. I have them connected to Home Assistant as temperature monitors, soil moisture monitors etc.
Carlos
Reviewed in the United States on June 13, 2024
Great value for the cost, completely satisfied with product.
A Bastien
Reviewed in Canada on February 7, 2024
I tested all of these with the Blink sketch when I first got them. Al worked fine. I have now been using them with Espresence and OpenHab. No problems so far ever.
CanadianTrooper
Reviewed in Canada on November 14, 2024
so far all good
Deoji
Reviewed in the United States on April 3, 2024
I really like the ESP32. They are a neat little device with endless possibilities.
MikeCA
Reviewed in Canada on April 29, 2024
One of the six units was DOA and I needed 6. Touching up with a soldering iron did not help. Will be putting the working units in the parts bin for other potential projects and ordering from another vendor... If you need them all working, then stay away.
Don D
Reviewed in Canada on April 11, 2024
One wouldn't connect to port but the other five worked perfect. The chip does self enabling which I really appreciate when setting up the program.
Cagt
Reviewed in Canada on November 18, 2023
Absolutely adore the ESP32! The Wi-Fi functionality makes WLED configuration a breeze. Just a heads up, the pin picture for this circuit is a bit wonky. But hey, aside from that hiccup, these modules are pure magic – top-notch quality that's hard to beat. Confession time: I did manage to goof up one myself, totally my bad. Despite that, still a fan! 🌟😊
Recommended Products

CA $22.99

CA $ 10 .99 CA $10.99

4.6
Select Option

CA $15.65

CA $ 6 .99 CA $6.99

4.3
Select Option

CA $50.58

CA $ 23 .99 CA $23.99

4.3
Select Option