Your cart is empty.
Your cart is empty.Buyers Products Corner Security Latch Set is a basic latch set for flat surface fastening and can be used for stake bodies, trailers, gates, and numerous other applications. Available in either a plain finish bolt-on style, zinc finish bolt-on style, or plain finish weld-on style, the set can be installed for either right- or left-hand operation. Pieces are also sold individually for customization and repair needs.
Jean Plante
Reviewed in Canada on June 18, 2024
Utilisé pour barrer le panneau arrière d’une remorque mais n’est pas satifaisant
victor
Reviewed in the United States on December 4, 2024
put on trailer tail gate
RDM
Reviewed in the United States on November 19, 2024
just right fit for welding to angle
LJ Moya
Reviewed in the United States on October 26, 2024
The were exactly like the ones that came in my utility trailer. I made the four gate a bifold gate and I needed the latch. Perfect.
Thomas R.
Reviewed in the United States on August 17, 2023
Arrived early and is impressive by its simple yet massive design. BUT, there are no suggestions, instructions or templates on how to mount it in the rear corner of a trailer, for instance. The alignment is absolutely critical and, to us average folks, it is not obvious. Once you drill holes you had better have properly aligned the plate that holds the lock with the lock plate or it’s too late. That no screws or bolts are included is understandable as this item is intended for an infinite number of applications. Disappointed. A simple template would yield five-stars.UPDATE: Fortunately there was room to drill another set of two holes for the lock arm and my project was saved. All could have been avoided with a simple template or drawing.
André
Reviewed in Canada on October 6, 2023
Rust as soon as water hits it
Customer
Reviewed in the United States on April 26, 2023
My new trailer had pins you dropped in and then have to push a R clip through. I always seemed to manage scrape a knuckle with those clips and then you have to lay them down somewhere and they always fall on the ground. That's why I love these latches. No parts to take off and lose, you just flip it up and pull it back to drop the gate and then push it back through and flip it down. The tab has a slight bend to it so when you push it down to lock it, it creates just a little tension. The parts are made very well and seem like they will hold up well. Mine are on a 6.5'x12' utility trailer with a full mesh ramp so it's not crazy heavy, but not light! I would buy these again in a heartbeat. You will need hardware to bolt them to the trailer. Tractor Supply has the best prices on stuff like that!
Recommended Products
