Your cart is empty.
Your cart is empty.Function:1-wifi function expansion, flash ESP32Marauder firmware by default, support sd card storage data2-2.4G module expansion, supporting NRF sniffer and mousejacker functions3-High gain CC1101 module, wide sub-ghz signal sending and receiving distanceApplicable models:For Flipper zeroShipping content:1 - A multi-function expansion board2. 2.4/5Ghz dual-band glue stick antennas3-40Mhz-6Ghz broadband telescopic antenna
Kelvin J Peters
Reviewed in Canada on April 13, 2025
Just what I needed
Akatun
Reviewed in Spain on June 20, 2024
Producto tal cual, funciona perfecto, buena pcb y buenos acabados, recomiendo...Llego antes de lo esperado.
Tommy Green
Reviewed in the United States on June 18, 2024
All the modules work great, however there are no instructions, so I'll provide my findings.The NRF24 and CC1011 work right out of the box, but as usual, you need to flash the ESP32. Here's how I did it.1. Put it in the ESP32 mode, which is the middle selection2. Went to Fzeeflasher.com3. While your board is not connected to your Flipper, hold down the "BT" button and connect it to your computer.4. On the website, click the "Connect" Button5. A window will pop-up and ask which device to connect to, choose, "ESP32-S2"6. Once connected, at the top drop-downs, choose, under model, "+KOKO MARAUDER, ESP-S2 (SD CARD)" and the current version and for firmware, "Marauder"7. Then click program. (You may need to Erase it first)8. Once completed. Connect it to your Flipper9. On your flipper, you should already have your alternate software (Momentum, Xtreme, etc...)10. Go to the GPIO section, Then ESP11. Find the ESP Flasher, and select it.12. Choose Quick Flash, then "Wifi Dev/ RL S2/ Xeon13. Done and should be working!Good luck and happy hunting.
MANUEL
Reviewed in Spain on May 7, 2024
gracias
@h4ckD4D
Reviewed in the United States on May 15, 2024
This module didn't work. There is no technical support, no manual or any link. I would like to know how to use it, there should be help for that. Video, manual, something. Thanks
Orbach
Reviewed in Canada on December 17, 2024
Need to flash the esp32 first (middle position)Other than that there’s a switch for the cc1101 (left position) and the nrf (right position)
Mathias
Reviewed in Germany on October 13, 2024
Es funktionieren beide Knöpfe nicht Flashmodus lässt sich nicht aktivieren.. RT/BTDa hat wohl einer oder "etwas" falsch gelötet..Nur der obere Knopf zum umschalten funktioniertHab genug Anleitungen durchgelesen und bin kein Neuling, jedoch das Modul geht einfach nicht
Recommended Products
