Your cart is empty.
Your cart is empty. Specification:
Condition: Brand New
Item Type: Vacuum Sucker Pen
Model: LP200
Color: Shown as Picture
Vacuum pen is available in straight and curved heads, it comes standard with three sizes of tips:
LN250: FACE SIZE 1/8" DIA. 3.2mm
LN260: FACE SIZE 1/4" DIA. 6.4mm
LN270: FACE SIZE 3/8" DIA. 9.5mm
Package List:
1 * Vacuum Suction Pen
3 * acuum Suction Pen Tips
Note:
1. Please allow slight error due to manual measurement. Thanks for your understanding.
2. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.
Vacuum Suction Pen Use Method:
When in use, aim the suction disc of the vacuum suction pen at the middle of the BGA element, then suck the component and remove it. (In between the BGA, the of the component should be cleaned well, otherwise it will affect the suction of the vacuum suction pen)
1. First select the suction cup that corresponds to the size of the IC to be drawn and installed on the suction pen nozzle.
2. After the suction pen is installed, place the suction cup flat on the IC.
3. Press the button on the suction pen to remove air from the vacuum device inside the pen, then release the button pen to produce vacuum suction to lift the IC
4. Place the suction IC in the position to be placed and press the button to remove air from the vacuum device in the pen so that the IC will fall off the suction cup.
Serge Poisson
Reviewed in Canada on February 18, 2025
The piece need to be very planned, straight and lite.
Recommended Products
