ELEGRP LIGHTING CONTROLS - Control your delight

• Universal Compatibility: Works with 150W dimmable LED, 150W CFL and 600W incandescent light bulbs on the market.
• Single-Pole or 3-Way: Can be used in single-pole or 3-Way applications.
• NO NEUTRAL WIRE REQUIRED: Ideal for homes of all ages.
• Ultra-Slim Profile: Easily fits in the electrical box and wall plate.
• High Quality: Energy-saving and long operating life. Tough thermoplastic housing shrugs off impacts and scratches. UL & CUL listed.

ELEGRP Digital Rotating Dimmer Switches

• High Compatibility: Reduce the probability of flicker. Not easily interfered by the power supply and loads.
• High Consistency: MCU integrated digital circuit control technology enables smooth dimming of the widest range of LEDs with high consistency.
• Fade ON Function: Lights fade up smoothly, allowing your eyes to adjust to the new light level. Reduce the current at the moment of turning on the light, so to prolong the service life of the bulbs and dimmer.
• Dimming Curve: Changeable dimming curve before manufacturing.

Minimum Brightness Setting Steps:

1. Turn on the light, and make sure the lamp is on.​

2. Press and hold the adjustment button for 3 seconds until you find the lamp starts to flash.

3. Release the adjustment button.

4. Adjust the slide bar or knob until the load light reaches the desired minimum brightness.​​

5. Press the adjustment button again to save the settings. If the load light flashes once again, the setting is successful.​

Single Pole and 3 Way Wiring

• Use only one dimmer in a 3-or-4-way circuit. The other 3-or-4-way switch(es) will turn the light on at the brightness level selected at the dimmer.
• For 3-way applications, note that one of the screw terminals from the old switch being removed will usually be a different color (Black) or labeled COMMON. Tag that wire with electrical tape and identify as the COMMON (Line or Load) in both the dimmer wall box and 3-way wall box.
• When multiple bulbs are controlled by one dimmer, do not mix bulb types. All bulbs shall be either LED, CFL or incandescent. Using the same make/model of each bulb will enhance dimmer performance.
• Form all wires carefully into wall box, mount dimmer but DO NOT install wall plate with mounting screws supplied until all sections are finished.

Trouble Shooting

1. The dimmer doesn't turn on the light.

• Check that the bulb is installed and has not failed.
• Check if the circuit breaker or fuse is connected properly.
• Check if the neutral line of the lamp is connected properly.

2. The light flicker throughout the dimming range.

• Check if there is a dimmable sign on the CFL or LED and make sure to use a dimmable CFL or LED light.
• The lighting fixture is not compatible with our dimmer.
• Most dimmable LEDs and CFLs will not achieve as low levels as incandescent or halogen sources.
• Control a group of lighting fixtures/lamps with one dimmer may cause flicker due to variation of dimming circuit and dimming range. Please use dimmer to control lights/lamps in the same type or same model.

3. CFL or LED lights flicker at low brightness.

• Go to Minimum Brightness Setting to turn up the minimum brightness level until it doesn’t flicker.